< Back ×
My Vehicle Change Vehicle
2009 Cadillac DTS
< Back to View All
Cameras & Driver Safety
- Department
- Prices
OEM (Genuine) 2009 Cadillac DTS Reverse Sensor
PartNumber: 25905389
Product Specifications- Notes: Dts; Front Object;Dts; Rear Object
- Other Names: Park Sensor, Reverse Sensor, Sensor
- Item Dimensions: 4.9 x 2.3 x 1.9 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2009 Cadillac DTS Reverse Sensor
Vehicle Fitment- 2009 Cadillac DTS | Base, Livery, Luxury, Platinum, Premium | 8 Cyl 4.6 L GAS
$247.73 MSRP:$373.74You Save: $126.01 (34%)
OEM (Genuine) 2009 Cadillac DTS Object Sensor
PartNumber: 20823460
Product Specifications- Notes: Blind Spot Monitoring; Dts
- Location: Driver Side; Passenger Side
- Other Names: Module, Object Sensor, Sensor
- Item Dimensions: 5.6 x 4.6 x 1.4 inches
- Item Weight: 1.00 Pounds
- Fitment Type: Direct Replacement
- Replaces: 1999430, 25978649, 25910830, 20759899, 01999430
- Part Description: 2009 Cadillac DTS Object Sensor
Vehicle Fitment- 2009 Cadillac DTS | Base, Livery, Luxury, Platinum, Premium | 8 Cyl 4.6 L GAS
$422.21 MSRP:$636.96You Save: $214.75 (34%)
FAQ for Parking Sensors Repair
Q: What is the rear object sensor housing service procedure?
A:
Remove the rear fascia, disconnect the sensor harness and remove the sensor from the sensor housing. Next, apply adhesive epoxy and install the sensor housing to the fascia. Install the sensor to the sensor housing and install the rear fascia.
By Bob
GM Specialist
02/11/2022Q: What is the rear object sensor removal procedure?
A:
Remove the rear bumper fascia and disconnect from the rear object sensor. Next, lift the locking tabs on the housing and remove the rear object sensor.
By Bob
GM Specialist
02/11/2022Q: What is the rear object sensor installation procedure?
A:
First, insert the sensor into the housing and connect the electrical connector to the rear object sensor. Next, install the rear bumper fascia.
By Bob
GM Specialist
02/11/2022Q: What is the information center telltale installation procedure?
A:
Connect the electrical connector to the information center telltale assembly and insert the display into the headliner until the locking tab locks into position. Finally, install the bezel by pushing it up until the tabs lock into position.
By Bob
GM Specialist
01/11/2022Q: What is the information center telltale removal procedure?
A:
Use a screwdriver to release the locking tab at the rear of the telltale assembly and tilt the display down. Pull down to remove and disconnect the electrical connector.
By Bob
GM Specialist
01/11/2022Q: What is the front and rear object alarm module service procedure?
A:
Remove the right side trim panel and disconnect the electrical connectors.
By Bob
GM Specialist
01/11/2022See more FAQs (1)