Part Description: 2009 Cadillac DTS Lever - Automatic Transmission Control
More Info
Vehicle Fitment
2009 Cadillac DTS | Base, Livery, Luxury, Platinum, Premium | 8 Cyl 4.6 L GAS
FAQ for Automatic Transmission Shift Levers Repair
Q: What is the torque spec for the shift fasteners?
A:
The proper torque spec is 9Nm (79 lb in).
By Bob
GM Specialist
01/11/2022
Q: Where is the Transmission Control located?
A:
To access the TC you must remove the console trim that surrounds the shifter (We recommend the use of gloves to protect from sharp trim pieces) be sure to depress the BTSI pin to release the shifter out of the park.
By Bob
GM Specialist
01/11/2022
Q: How do I install the shift lever?
A:
Apply light pressure to remove the boot from the column trim.
By Bob
GM Specialist
01/11/2022
Q: What torque spec is required for the shift lever bolt?
A:
Torque the bolt to 20NM (15lb in).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: Why is my gear selector not reflecting the appropriate gear on my dash?
A:
If you did not have the gear selector in NEUTRAL when adjusting, this is a result.
Q: How do I access the brackets mounting bolts?
A:
You will need to lift the engine frame slightly to have clearance to reach the bolts.
Q: What is the vehicle speed sensor installation procedure?
A:
First, install the vehicle speed sensor and the retaining bolt. Next, install the new O-ring on the sensor and tighten the bolt to 10 Nm. Install the electrical connector at the sensor, install the bolts and lower the vehicle.