Part Description: 2009 Buick LaCrosse Cable Asm-Parking Brake Rear
More Info
Vehicle Fitment
2009 Buick LaCrosse | CX, CXL, CXS, Super | 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 8 Cyl 5.3 L GAS
FAQ for Parking Brake Cable Repair
Q: What are the procedures to install the parking brake cable equalizer?
A:
The procedures are to remove the equalizer nut from the adjustment stud and disconnect the front park brake cable and remove the equalizer assembly.
By Bob
GM Specialist
27/12/2021
Q: How do you install the parking brake rear cable?
A:
You can install the rear cable by installing the following: the cable end into the caliper lever, the brake caliper guide pin, the equalizer stud, and the rear tire and wheel.
By Bob
GM Specialist
23/12/2021
Q: What is the installation procedure for the parking brake front cable?
A:
The procedure is to install the following: the front cable, the cable button into the clevis and retaining clip, and install the park brake cable to the equalizer.
By Omar
GM Specialist
22/12/2021
Q: What is the proper way to remove the parking brake rear cable?
A:
The proper way is to remove the rear tire and the rear brake caliper, rotate the caliper and parking brake cable and remove the park brake cable.
By Bob
GM Specialist
15/12/2021
Q: How do you remove the parking brake front cable?
A:
To remove the parking brake front cable, you have to relieve the cable tension, disconnect the front cable, remove the retaining clip and remove the front cable.
By Bob
GM Specialist
24/11/2020
FAQ for Other Repair Info
Q: What is the proper way to install the rear brake caliper?
A:
The proper way is to clean all the parts in denatured alcohol, dry them with low pressure, and install the brake pad retainers, the brake pads, and the Brake Caliper.
Q: What are the procedures for the master cylinder bench bleeding?
A:
The procedures are to secure the mounting flange of the Brake Master Cylinder and remove the cylinder reservoir, transparent hoses, and the master cylinder.
Q: What is the removal procedure for the intermediate steering shaft?
A:
The procedure is to position the seal to prove access to the pinch bolts and remove the bolts and the intermediate Steering Shaft.