Part Description: 2009 Buick LaCrosse Caliper Kit, Front Brake
More Info
Vehicle Fitment
2009 Buick LaCrosse | CX, CXL, CXS | 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS
FAQ for Brake Caliper Repair Kit Repair
Q: What is the proper way to remove the rear brake caliper overhaul?
A:
The proper way is to remove the following: the rear brake caliper, the brake caliper piston, retaining rings, and remove the piston dust boot seal.
By Omar
GM Specialist
30/12/2021
Q: What is the installation procedure for the front brake caliper overhaul?
A:
The procedure is to install the new piston seal, the caliper piston into the caliper bore, the new dust boot seal, and install the bleeder valve.
By Bob
GM Specialist
15/12/2021
Q: How do you install the rear brake caliper overhaul?
A:
You can install the rear brake caliper overhaul, install the bottom half of the caliper piston, install the dust boot seal and the retaining rings, and install the bleeder valve.
By Bob
GM Specialist
18/10/2021
Q: How do you remove the front brake caliper overhaul?
A:
You can remove the front brake caliper by removing the front brake, the brake caliper piston, and the bleeder valve from the caliper.
By Bob
GM Specialist
24/11/2020
FAQ for Other Repair Info
Q: What are the procedures for the master cylinder bench bleeding?
A:
The procedures are to secure the mounting flange of the Brake Master Cylinder and remove the cylinder reservoir, transparent hoses, and the master cylinder.
Q: What is the power vacuum brake booster (L26) (3.8L) removal procedure?
A:
First, disconnect the negative battery cable, remove the left instrument panel insulator panel, and remove the vacuum power booster pushrod nut. Next, remove the brake pedal pushrod bushing, and disconnect the vacuum power Brake Booster pushrod from the brake pedal. After that remove the fuel injector sight shield, disconnect the brake fluid level sensor electrical connector, and remove the 2 master cylinder nuts. Next, remove and place aside the master cylinder, secure the master cylinder with heavy mechanics wire, and remove aside the vacuum power brake booster check valve. Install the J 22805-B to the vacuum power brake booster, and while pressing the locking tab, rotate the vacuum power brake booster counterclockwise. Finally, remove the vacuum power brake booster, and remove the J 22805-B from the vacuum power brake booster.
Q: How do you prevent brake fluid spills?
A:
You can prevent brake fluid spills by placing a clean cloth under the master cylinder.