Part Description: 2008 GMC Yukon Heater Asm-Windshield Washer Solvent
More Info
Vehicle Fitment
2008 GMC Yukon | Denali, Hybrid, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L GAS
$104.26MSRP: $210.27
You Save: $106.01 (51%)
FAQ for Windshield Washer Hose Repair
Q: What is the tip when you replace the Windshield Washer Hose?
A:
The tips are that you should disconnect the hose at the left rear fender flange and route the new hose to the same location as the old hose was removed from.
By Bob
GM Specialist
01/11/2022
Q: What is the preliminary procedure for the Windshield Washer Hose Replacement?
A:
You should open the hood, remove the left front wheelhouse liner and disconnect the washer hose from the washer pump spout.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How do you clean the Wiper Blade?
A:
You can lift the Wiper Blade assemblies off of the windshield glass, clean the wiper blade element with a clean cloth saturated with full-strength washer solution, rinse the wiper blade assemblies with water and place the wiper blade assemblies back onto the windshield glass.
Q: How many nuts does the windshield washer solvent heater assembly have?
A:
The windshield washer solvent heater assembly has a total of 2 nuts.
Q: How do you replace the Windshield Outside Moisture Sensor?
A:
You can gently pry the trim cover outward to remove the cover from the rain sensor module, disconnect the electrical connector, disengage the retaining clips from the mounting bracket on the windshield, disengage the rain sensor lens from the module by disengaging the retainer clips and clean the windshield where the old conductive jell residue is present.