Part Description: 2008 GMC Yukon Cover Asm-Engine Front
More Info
Vehicle Fitment
2008 GMC Yukon | SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
FAQ for Timing Cover Repair
Q: What is the required tool for the Engine Front Cover Replacement?
A:
The required tool is the J 41476 Front and Rear Cover Alignment Tool.
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque for the CMP actuator bolts?
A:
The recommended torque is 12 N.m(106 lb in).
By Bob
GM Specialist
02/11/2022
Q: What is the recommended torque for the CMP sensor wire harness bolts?
A:
The recommended torque is 12 N.m(106 lb in).
By Bob
GM Specialist
02/11/2022
FAQ for Other Repair Info
Q: How do you remove the Drive Belt Idler Pulley?
A:
You can remove the accessory drive belt, loosen the drive belt Idler Pulley bolt and remove the idler pulley.
Q: What are the required tools for the Timing Chain and Sprocket Replacement?
A:
The required tools are the EN 46330 Timing Chain Tensioner Retaining Pin, the J 8433 Puller Bar, the J 41478 Crankshaft Front Oil Seal Installer, the J 41558 Crankshaft Sprocket Remover, the J 41665 Crankshaft Balancer and Sprocket Installer, the J 41816-2 Crankshaft End Protector, the J 42386-A Flywheel Holding Tool and the J 45059 Angle Meter.
Q: What's the installation procedure for the drive belt tensioner?
A:
You should position the drive Belt Tensioner to the water pump, install and tighten the drive belt tensioner bolts and install the accessory drive belt.