2008 GMC Yukon Shock Absorber

The electronic Power Steering Control Module has a total of 3 bolts.

You can set the front wheels in the straight-ahead position, install anti-rotation pin J 42640 in the steering column lower access hole, remove the engine shield, mark the relationships of the Steering Shaft coupling, remove the steering shaft coupling bolt, remove the steering shaft coupling nut and bolt and remove the steering shaft coupling from the vehicle.

You should inspect the capsules on the Steering Column bracket assembly, and all capsules must be securely seated in the bracket slots and checked for any loose conditions when pushed or pulled by hand, if not, the bracket should be replaced if bolted to the jacket assembly. you should inspect for jacket assembly collapse by measuring the distance from the steering column support bracket mounting plate to the lower edge of the jacket lower bracket and replace the jacket assembly if the measured dimensions are less than 286 mm. you should visually inspect the steering shaft for sheared injected plastic and if the steering shaft shows sheared plastic, replace the steering shaft. you should inspect the steering shaft runout for any frame damage that could cause a bent steering shaft.