2008 GMC Yukon Rain Sensors

You can gently pry the trim cover outward to remove the cover from the rain sensor module, disconnect the electrical connector, disengage the retaining clips from the mounting bracket on the windshield, disengage the rain sensor lens from the module by disengaging the retainer clips and clean the windshield where the old conductive jell residue is present.

The tips are that the rain sensor bracket is not serviced separately and you should replace the windshield if the rain sensor bracket is loose or has been damaged.

You can remove the rain sensor module from the windshield bracket, wearing latex rubber gloves, hold the moisture sensor in the left or right hand, release the 3 clips securing the lens to the sensor, discard the old moisture sensor lens, remove the old conductive jell residue from the windshield mounting bracket, clean the area of the windshield, align and secure the two sensor halves back as one unit, remove the plastic protective covering from the lens, position and install the moisture sensor back onto the windshield bracket, connect the electrical cover and secure the rain sensor module trim cover.