2008 GMC Yukon | AT4, Denali, Denali Hybrid, Hybrid, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
$47.87MSRP: $90.34
You Save: $42.47 (48%)
FAQ for Oil Pressure Sensor Repair
Q: What is the required tool for the J 41712 Oil Pressure Switch Socket?
A:
The required tool is the J 41712 Oil Pressure Switch Socket.
By Bob
GM Specialist
01/11/2022
Q: How do you remove the Engine Oil Pressure Sensor and/or Switch?
A:
You should remove the intake manifold, disconnect the engine harness electrical connector, and use the J 41712 or equivalent to remove the oil pressure sensor and washer.
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the oil pressure sensor?
A:
The recommended torque is 35 N.m.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What's the recommended torque for the oil level sensor?
A:
The recommended torque is 20 N.m(15 lb-ft).
Q: What conditions should the vehicle meet when you install the accelerator pedal position sensor?
A:
The vehicle should not be in a reduced engine power mode. the ignition should be on. the engine should be off.
Q: What's the recommended torque for the CMP sensor wire harness bolts?