FAQ for Hvac Heater Blend Door Actuator Repair
Q: What's the recommended torque for the temp door actuator screws?
A:
The recommended torque is 2.5 Nm.
By BobGM Specialist
01/11/2022 Q: How do you replace the mode actuator?
A:
You can remove the knee bolster, remove the air outlet duct-floor LH, disconnect the electrical connector from the mode actuator and re-calibrate the mode actuator.
By BobGM Specialist
01/11/2022 Q: How do you replace the mode valve actuator?
A:
You can remove the right rear quarter trim panel, reposition the auxiliary HVAC module inward to gain access to the mix door actuator, disconnect the electrical connector from the mix door actuator and re-calibrate the mode actuator.
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the mix door actuator screw?
A:
The recommended torque is 2.5 Nm.
By BobGM Specialist
01/11/2022 Q: How do you replace the recirculation actuator?
A:
You can open the instrument panel compartment door, release the instrument panel compartment door stop, allow the instrument panel compartment door to open completely, disconnect the electrical connector from the recirculation actuator and re-calibrate the recirculation actuator.
By BobGM Specialist
01/11/2022 Q: What should you do to avoid actuator damage?
A:
You should not apply power to the actuator when it is not installed in the HVAC module.
By BobGM Specialist
01/11/2022 Q: How do you replace the temperature valve actuator?
A:
You can remove the right rear quarter trim panel, reposition the auxiliary HVAC module inward to gain access to the temp door actuator, disconnect the electrical connector from the temp actuator and re-calibrate the air temp actuator.
By BobGM Specialist
01/11/2022 Q: How many screws does the recirculation actuator have?
A:
The recirculation actuator has a total of 2 screws.
By BobGM Specialist
01/11/2022 Q: How many screws does the temp door actuator have?
A:
The temp door actuator has a total of 2 screws.
By BobGM Specialist
01/11/2022 Q: How do you replace the air temperature actuator?
A:
You can remove the instrument panel center trim panel, disconnect the electrical connector from the air temp actuator and re-calibrate the air temp actuator.
By BobGM Specialist
01/11/2022 See more FAQs (7)