2008 GMC Yukon | Denali Hybrid, Hybrid | 8 Cyl 6.0 L ELECTRIC/FLEX, 8 Cyl 6.0 L ELECTRIC/GAS
$199.87MSRP: $347.85
You Save: $147.98 (43%)
FAQ for Camshaft Repair
Q: What's the recommended torque for the CMP actuator solenoid valve?
A:
The recommended torque is 65 Nm.
By Bob
GM Specialist
29/10/2022
Q: What should you do when you remove the starter motor?
A:
You should ensure that the teeth of the J 42386-A mesh with the teeth of the engine flywheel.
By Bob
GM Specialist
29/10/2022
Q: What's the removal procedure for the camshaft position actuator magnet?
A:
You should remove the water pump, disconnect the engine harness electrical connector from the camshaft position (CMP) actuator magnet, remove the CMP actuator magnet bolts and magnet, and remove and discard the CMP actuator magnet gasket.
By Bob
GM Specialist
29/10/2022
Q: What's the removal procedure for the camshaft position actuator solenoid valve?
A:
You should remove the camshaft position (CMP) actuator magnet and remove and discard the CMP actuator solenoid valve.
By Bob
GM Specialist
29/10/2022
Q: What's the recommended torque for the CMP actuator magnet belts?
A:
The recommended torque is 12 Nm.
By Bob
GM Specialist
29/10/2022
Q: What is the required tool for the camshaft position actuator solenoid valve replacement?
A:
The required tool is the J 45059 Angle Meter.
By Bob
GM Specialist
29/10/2022
Q: What should you do during the removal or installation procedure for the camshaft position actuator?
A:
You should not push or pull on the reluctor wheel of the camshaft position (CMP) actuator, because this may dislodge the wheel from the front of the actuator.
By Bob
GM Specialist
29/10/2022
Q: What are the required tools for the camshaft position actuator?
A:
The required tools are the EN 46330 Timing Belt Tensioner Retaining Pin, the J 42386-A Flywheel Holding Tool, and the J 45059 Angle Meter.
By Bob
GM Specialist
29/10/2022
See more FAQs (3)
FAQ for Other Repair Info
Q: How do you remove the Drive Belt Idler Pulley?
A:
You can remove the accessory drive belt, loosen the drive belt Idler Pulley bolt and remove the idler pulley.
Q: What are the required tools for the Timing Chain and Sprocket Replacement?
A:
The required tools are the EN 46330 Timing Chain Tensioner Retaining Pin, the J 8433 Puller Bar, the J 41478 Crankshaft Front Oil Seal Installer, the J 41558 Crankshaft Sprocket Remover, the J 41665 Crankshaft Balancer and Sprocket Installer, the J 41816-2 Crankshaft End Protector, the J 42386-A Flywheel Holding Tool and the J 45059 Angle Meter.
Q: What's the removal procedure for the drive belt tensioner?
A:
You should remove the accessory drive belt, the drive Belt Tensioner bolts, and the drive belt tensioner.