2008 GMC Yukon | Denali, Hybrid, SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L ELECTRIC/GAS, 8 Cyl 6.2 L GAS
FAQ for Abs Control Module Repair
Q: What's the recommended torque for the EBCM screw?
A:
The recommended torque is 3 Nm.
By Bob
GM Specialist
01/11/2022
Q: How do you remove the electronic brake control module?
A:
You should remove all dirt and debris from the electronic brake control module (EBCM) and the brake pressure modulator valve (BPMV), disconnect the EBCM electrical connector, remove and discard the EBCM to BPMV screws and pull the EBCM (1) from the BPMV.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What's the preliminary procedure for the Parking Brake Shoe Replacement?
A:
You should raise and support the vehicle, remove the brake rotor and disconnect the park brake cable from the actuator.
Q: How do you remove the Rear Wheel Speed Sensor?
A:
You can raise and support the vehicle, disconnect the electrical connector, remove the wheel speed sensor retaining bolt, release the wheel speed sensor wiring harness from the retainers and remove the wheel speed sensor.