< Back ×
My Vehicle Change Vehicle
2008 Chevrolet Impala
< Back to View All
A/C & Heating
- Department
- Prices
OEM (Genuine) 2008 Chevrolet Impala AC Relay
PartNumber: 13500114
Product Specifications- Notes: Impala, Monte Carlo; A/C;Pcm;Starter
- Item Dimensions: 3.8 x 2.2 x 0.7 inches
- Item Weight: 0.40 Pounds
- Fitment Type: Direct Replacement
- Replaces: 12193606, 19115080, 15328866, 12135034, 15393412, 12088567, 12135170, 19116057
- Part Description: 2008 Chevrolet Impala AC Relay
Vehicle Fitment- 2008 Chevrolet Impala | 50th Anniversary Edition, Base, Eco, LS, LS Sport, LT, LTZ, Police, Premier, SS | 4 Cyl 2.4 L ELECTRIC/GAS, 4 Cyl 2.5 L FLEX, 4 Cyl 2.5 L GAS, 6 Cyl 3.4 L GAS, 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L BI-FUEL, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
$9.55 MSRP:$20.04You Save: $10.49 (53%)
FAQ for Hvac Control Module Repair
Q: How many blower motor resistor screws are needed when installing the blower motor control module?
A:
2blower motor resistor screws attach.
By Bob
GM Specialist
01/11/2022Q: What's the recommended torque for the heater and A/C control assembly?
A:
The recommended torque is 1.5 N.m (13 lb in).
By Bob
GM Specialist
01/11/2022Q: How many heater and A/C control assemblies are needed when replacing the heater and air conditioning control?
A:
2heater and A/C control assembly attach.
By Bob
GM Specialist
01/11/2022Q: What should be done before replacing the blower motor control module?
A:
You will need to remove the right closeout insulator, then disconnect the blower motor resistor electrical connector.
By Bob
GM Specialist
01/11/2022Q: What should be noticed about the Service Programming System?
A:
You shouldn't program a control module unless you are directed by a service procedure or you are directed by a General Motors Corporation service bulletin. Programming a control module at any other time will not permanently correct a customer's concern. It is essential that the Multiple Diagnostic Interface (MDI) or Tech 2(R) and the TIS terminal are equipped with the latest software before performing (SPS). Due to the time requirements of programming a controller, it is recommended that an external power source be used to maintain system voltage. Stable battery voltage is critical during programming. Any fluctuation, spiking, over voltage, or loss of voltage will interrupt programming.
By Bob
GM Specialist
01/11/2022Q: What should be done before replacing the heater and air conditioning control?
A:
You will need to remove the accessory trim plate.
By Bob
GM Specialist
01/11/2022See more FAQs (1)