< Back ×
My Vehicle Change Vehicle
2008 Chevrolet Impala
< Back to View All
Lift Supports
- Department
- Brands
- Prices
OEM (Genuine) 2008 Chevrolet Impala Support Cylinder
PartNumber: 15833919
Product Specifications- Location: Driver Side
- Other Names: Lift Cylinder, Support Cylinder
- Item Dimensions: 17.3 x 1.7 x 0.8 inches
- Item Weight: 0.80 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2008 Chevrolet Impala Support Cylinder
Vehicle Fitment- 2008 Chevrolet Impala | 50th Anniversary Edition, LS, LT, LTZ, Police, SS | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
$24.81 MSRP:$37.43You Save: $12.62 (34%)
StrongArm® Hood Lift Support for 2008 Chevrolet Impala
PartNumber: 4582Product Specifications- Body: 18.00
- BODY CONNECTION: ball socket (nylon) 10mm
- Brackets: No
- Compressed Length: 13.87
- Extended Length: 21.12
- Force: 112.00
- Hardware Kit: No
- High Performance Item: N
- Internal Springs: No
- Is Application Specific: Y
- Material: Heavy gauge steel pressure tube provides long life; Rubber o-ring piston seal for controlled lift; Teflon backup ring gives enhanced performance
- Shaft: 8.00
- SHAFT CONNECTION: ball socket (nylon) 8mm
- Stroke: 7.25
- UPC: 845998009969
- Part Description: 2008 Chevrolet Impala Hood Lift Support
Vehicle Fitment- 2008 Chevrolet Impala | All Trims | All Engines
$13.01
FAQ for Hood Lift Support Repair
Q: What's the tip for replacing the hood open assist rod?
A:
You may remove the metal clip at the end of the assist rod, then pull away from the start.
By Bob
GM Specialist
01/11/2022Q: What should you be careful about when replacing the hood open assist rod?
A:
When a hood hold open device is being replaced, you shall provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
By Bob
GM Specialist
01/11/2022Q: What should not be done when replacing the hood open assist rod?
A:
You must not apply pressure to the middle of the rod because the damage will result. Instead, you should apply pressure only at the end of the hood assist rod while replacing it.
By Bob
GM Specialist
01/11/2022