Part Description: 2008 Chevrolet Impala Bracket Bolt
More Info
Vehicle Fitment
2008 Chevrolet Impala | 50th Anniversary Edition, LS, LT, LTZ, Police, SS | 4 Cyl 2.5 L FLEX, 4 Cyl 2.5 L GAS, 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L BI-FUEL, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
Part Description: 2008 Chevrolet Impala Radiator Pressure Equalizer Hose
More Info
Vehicle Fitment
2008 Chevrolet Impala | SS | 8 Cyl 5.3 L GAS
FAQ for Coolant Hose Repair
Q: What should be done before removing the thermal bypass hose from the crossover pipe?
A:
You will need to reposition the thermal bypass hose clamp at the crossover pipe.
By Bob
GM Specialist
01/11/2022
Q: What should be done before installing the coolant crossover pipe bolts?
A:
You will need to position the coolant crossover pipe to the cylinder heads.
By Bob
GM Specialist
01/11/2022
Q: What's the recommended torque for the coolant crossover pipe bolts?
A:
The recommended torque is 50 N.m (37 lb-ft).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to remove the water pump?
A:
You will need to drain the cooling system, loosen the Water Pump pulley bolts, remove the drive belt, remove the water pump pulley bolts and pulley, remove the water pump bolts and the water pump and gasket, then clean the water pump mating surfaces.
Q: What's the removal procedure for the engine coolant thermostat housing?
A:
The removal procedure is to drain the cooling system, remove the air cleaner outlet duct, reposition the radiator outlet hose clamp at the Thermostat Housing, remove the radiator outlet hose from the thermostat housing, remove the thermostat housing bolt/stud and the thermostat housing and gasket and clean the gasket surfaces.
Q: What's the recommended torque for the weatherstrip retainer screws?