< Back ×
My Vehicle Change Vehicle
2008 Chevrolet Corvette
< Back to View All
Control Arms & Suspension Rods
- Department
- Prices
OEM (Genuine) 2008 Chevrolet Corvette Rear Suspension Knuckle
PartNumber: 88965637
Product Specifications- Notes: Corvette; Left; Corvette; Right; Base & 427; Z06, Zr1 & Grand Sport
- Location: Driver Side
- Other Names: Knuckle
- Item Dimensions: 5.5 x 13.7 x 12.8 inches
- Item Weight: 6.10 Pounds
- Fitment Type: Direct Replacement
- Replaces: 88964148
- Part Description: 2008 Chevrolet Corvette Rear Suspension Knuckle
Vehicle Fitment- 2008 Chevrolet Corvette | 427, 427 Limited Edition Z06, Base, Grand Sport, Z06, Z06 Carbon, ZR1 | 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS
OEM (Genuine) 2008 Chevrolet Corvette Knuckle
PartNumber: 88965638
Product Specifications- Notes: Corvette; Right; Corvette; Left; Base & 427; Z06, Zr1 & Grand Sport
- Location: Passenger Side
- Other Names: Knuckle
- Item Dimensions: 13.5 x 13.0 x 5.5 inches
- Item Weight: 5.60 Pounds
- Fitment Type: Direct Replacement
- Replaces: 88964149
- Part Description: 2008 Chevrolet Corvette Knuckle
Vehicle Fitment- 2008 Chevrolet Corvette | 427, 427 Limited Edition Z06, Base, Grand Sport, Z06, Z06 Carbon, ZR1 | 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS
FAQ for Steering Knuckle Repair
Q: What is the removal procedure for the knuckle?
A:
The procedure is to remove the tire and wheel assembly, the brake rotor, the spindle nut retainer, the spindle nut, the washer, and the suspension knuckle.
By Bob
GM Specialist
02/11/2022Q: What is the installation procedure for the steering knuckle?
A:
The procedure is to install the steering knuckle to the upper control arm and the lower control arm, the steering linkage outer tie rod ball stud, the stabilizer shaft link, the brake rotor and caliper, and the tire and wheel assembly.
By Bob
GM Specialist
02/11/2022Q: What special tool will I need when servicing the steering knuckle?
A:
You will need a ball joint separator.
By Bob
GM Specialist
02/11/2022Q: What is the removal procedure for the steering knuckle?
A:
The procedure is to remove the brake caliper and rotor, the stabilizer shaft link, and the steering knuckle from the vehicle.
By Bob
GM Specialist
02/11/2022Q: What is the installation procedure for the knuckle?
A:
The procedure is to install the suspension knuckle to the lower control arm ball joint stud, the suspension knuckle ball joint stud, the spindle nut, washer and retainer, the outer tie rod end to the suspension knuckle, the brake rotor and caliper and the tire and wheel assembly.
By Bob
GM Specialist
02/11/2022