2008 Chevrolet Corvette Floor Pan

2retainers attach the push pin.

You can place the carpet over the floor, install the carpet air outlet into the carpet to the passenger side only, rotate the air outlet 45 degrees counterclockwise and insert the outlet into the front of the carpet, rotate the air outlet 45 degrees clockwise to lock in position, connect the air duct to the carpet air outlet on the passenger side only and then tuck the carpet under the accelerator pedal. And then you can install the accelerator pedal stop, tuck the carpet under the instrument panel and accessory trim plate, pull the seat electrical connector through the slit in the carpet, install the side sill trim plate, replace the intermediate carpet over the floor carpet and then install the seat.

You should spray GM Vehicle Care Odor Eliminator directly or as an additive with carpet shampoo in steam cleaners, not use on any interior surface that plain water would deteriorate, complete eight-page treatment sheets are enclosed within each case of GM Vehicle Care Odor Eliminator and then call to obtain additional information and usage suggestions.

The recommended torque is 19 N.m (89 lb in).

You can lift the sill plate, unsnap the sill plate from the hinge pillar, and then slide the sill plate out from under the hinge pillar upper trim, and on the driver's side out from around the hood release handle and the footrest.