Part Description: 2008 Chevrolet Corvette Lower Hinge
More Info
Vehicle Fitment
2008 Chevrolet Corvette | 427, 427 Limited Edition Z06, 50th Anniversary Edition, 50th Anniversary Edition Pace Car, Base, Grand Sport, Indianapolis 500 Pace Car, Z06, Z06 Carbon, ZR1 | 8 Cyl 5.7 L GAS, 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS
Part Description: 2008 Chevrolet Corvette Upper Hinge
More Info
Vehicle Fitment
2008 Chevrolet Corvette | 427, 427 Limited Edition Z06, 50th Anniversary Edition, 50th Anniversary Edition Pace Car, Base, Grand Sport, Indianapolis 500 Pace Car, Z06, Z06 Carbon, ZR1 | 8 Cyl 5.7 L GAS, 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS
Part Description: 2008 Chevrolet Corvette Upper Hinge
More Info
Vehicle Fitment
2008 Chevrolet Corvette | 427, 427 Limited Edition Z06, 50th Anniversary Edition, 50th Anniversary Edition Pace Car, Base, Grand Sport, Indianapolis 500 Pace Car, Z06, Z06 Carbon, ZR1 | 8 Cyl 5.7 L GAS, 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS
Part Description: 2008 Chevrolet Corvette Hinge Asm-Rear Compartment Lid
More Info
Vehicle Fitment
2008 Chevrolet Corvette | 427, Base, Grand Sport | 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS
FAQ for Door Hinge Repair
Q: How many bolts attach to the front side door hinge upper?
A:
2 Bolts attach the front side door hinge upper.
By Bob
GM Specialist
01/11/2022
Q: How many bolts attach the front side door hinge lower?
A:
2 Bolts attach the front side door hinge lower.
By Bob
GM Specialist
01/11/2022
Q: What should be noted for the striker?
A:
You should adjust the striker as needed.
By Bob
GM Specialist
29/10/2022
Q: How many screws attach to the front side door lock striker?
A:
2screws attach to the front side door lock striker.
By Bob
GM Specialist
29/10/2022
Q: What is the recommended torque for the front side door lock striker screw?
A:
The recommended torque is 24 N.m (18 lb-ft).
By Bob
GM Specialist
29/10/2022
FAQ for Other Repair Info
Q: What is the installation procedure for the door lock status indicator?
A:
The procedure is to disconnect the harness connector from the Door Lock indicator, route the wire harness and connect it to the door trim panel and then install the door lock indicator to the door trim panel.
Q: How to install the door inside manual release actuator?
A:
You can engage the cable end, rotate the door release assembly forward, position the cable sheath, install the fasteners to the backside of the door release actuator, install both fasteners and then install both fastener trim plugs.
Q: What is the installation procedure for the door control module?
A:
The procedure is to install the window regulator to the door and then install the door trim panel.