< Back ×
My Vehicle Change Vehicle
2008 Chevrolet Corvette
< Back to View All
Light Relays, Switches & Control Modules
- Department
- Prices
OEM (Genuine) 2008 Chevrolet Corvette Sensor
PartNumber: 13597429
Product Specifications- Notes: Corvette
- Other Names: Clutch Switch, Sensor, Stoplamp Switch
- Item Dimensions: 3.7 x 3.3 x 1.8 inches
- Item Weight: 0.40 Pounds
- Fitment Type: Direct Replacement
- Replaces: 89047699
- Part Description: 2008 Chevrolet Corvette Sensor
Vehicle Fitment- 2008 Chevrolet Corvette | 427, 427 Limited Edition Z06, Base, Grand Sport, Stingray, Z06, Z06 Carbon, ZR1 | 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS
$12.08 MSRP:$19.25You Save: $7.17 (38%)OEM (Genuine) 2008 Chevrolet Corvette Stoplamp Switch
PartNumber: 13579090
Product Specifications- Notes: Corvette; Pedal Position Sensor
- Other Names: Stoplamp Switch
- Item Dimensions: 3.1 x 2.1 x 2.1 inches
- Item Weight: 0.40 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2008 Chevrolet Corvette Stoplamp Switch
Vehicle Fitment- 2008 Chevrolet Corvette | 427, 427 Limited Edition Z06, Base, Grand Sport, Z06, Z06 Carbon, ZR1 | 8 Cyl 6.0 L GAS, 8 Cyl 6.2 L GAS, 8 Cyl 7.0 L GAS
$8.76 MSRP:$16.50You Save: $7.74 (47%)
FAQ for Brake Light Switches Repair
Q: What is the calibration procedure for the brake pedal position sensor?
A:
The procedure is to apply the parking brake, place the transmission in the park position for automatic transmission or neutral for manual transmission, install a scan tool, turn on the ignition, with the engine off, navigate to the vehicle control systems menu, select computer/integrating systems menu item, select module setup menu item, select body control module (BCM) menu and then select the Brake Pedal Position (BPP) sensor calibration and follow the directions displayed on the screen.
By Bob
GM Specialist
29/10/2022Q: What is the removal procedure for the brake pedal position sensor?
A:
The procedure is to remove the instrument panel (I/P) insulator, disengage but do not remove the connector position assurance (CPA) on the connector, disconnect the electrical connector, remove the screw and then remove the brake pedal position sensor.
By Bob
GM Specialist
29/10/2022Q: What is the installation procedure for the brake pedal position sensor?
A:
The procedure is to place the sensor fork to the pin, rotate the sensor to align the sensor locator to the hole in the extension bracket, install the brake pedal position sensor screw, connect the electrical connector and then install the I/P insulator.
By Bob
GM Specialist
29/10/2022Q: What is the recommended torque for the brake pedal position sensor screw?
A:
The recommended torque is 2 N.m (18 lb in).
By Bob
GM Specialist
29/10/2022