FAQ for Steering Gearbox Repair
Q: What is the adjustment procedure for the Steering Gear Rack Bearing Preload?
A:
Loosen the adjuster plug lock nut. Tighten the adjuster plug. Tighten the adjuster plug lock nut to the steering gear housing.
By OmarGM Specialist
21/02/2022 Q: What is the installation procedure for the Steering Gear Cylinder Pipe Assembly and Seals?
A:
Inspect the cylinder lines for cracks, dents, and damage to the threads. Replace the parts as needed. Install the new O-ring seals to the valve end of the cylinder lines. Install the cylinder line assemblies to the gear assembly.
By BobGM Specialist
16/02/2022 Q: What is the recommended bolt torque for the isolator clamp bolts?
A:
The recommended bolt torque is 100 N.m (74 lb-ft).
By OmarGM Specialist
15/02/2022 Q: What is the recommended bolt torque for the long bolts?
A:
The recommended bolt torque is 130 N.m (96 lb-ft).
By OmarGM Specialist
15/02/2022 Q: What is the removal procedure for the Steering Gear Cylinder Pipe Assembly and Seals?
A:
Loosen both cylinder line fittings. Remove both cylinder line assemblies. Remove the O-ring seals. Discard the O-ring seals.
By OmarGM Specialist
10/02/2022 Q: What should you do after removing the boot?
A:
Inspect the inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear.
By OmarGM Specialist
09/02/2022 Q: What should you do before servicing the Steering Gear?
A:
Lift and support the vehicle.
By BobGM Specialist
09/02/2022 Q: What special tool will I need when servicing the Steering Gear Boot and Breather Tube?
A:
You will need keystone clamp pliers.
By OmarGM Specialist
09/02/2022 See more FAQs (3)