Part Description: 2008 Chevrolet Colorado Pipe Asm, Steering Gear (Long)
More Info
Vehicle Fitment
2008 Chevrolet Colorado | LS, LT, WT | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
FAQ for Power Steering Hose Repair
Q: What is the recommended bolt torque for the power steering gear retaining bolt?
A:
The recommended bolt torque is 12 N.m (106 lb in).
By Omar
GM Specialist
15/02/2022
Q: What special tool will I need when servicing the Power Steering Gear Inlet and Outlet Hose?
A:
You will need a power steering gear oil seal remover/installer.
By Omar
GM Specialist
09/02/2022
FAQ for Other Repair Info
Q: How do I refinish the brake drums?
A:
Measure the largest diameter of the Brake Drum. Clean the rust from the brake drum flange. Refinish the brake drum. Create a non-directional braking surface. Clean the braking surfaces.
Q: What is the installation procedure for the Rear Brake Hose?
A:
Install the Brake Line and the new retaining clip. Position the rear brake hose on the mounting bracket. Install the mounting bolt. Remove the rubber plug or cap. Install the brake line to the brake hose. Fill the master cylinder reservoir. Bleed the brake system. Lower the vehicle.
Q: What is the installation procedure for the Vacuum Brake Booster Check Valve and/or Hose?
A:
Connect the vacuum Brake Booster hose to the engine. Install the vacuum brake booster check valve to the hose. Install the vacuum brake booster hose clamp to the check valve. Install the vacuum brake booster check valve to the vacuum brake booster.