FAQ for Interior Door Handle Repair
Q: What is the installation procedure for the Assist Handle?
A:
Position the assist handle over the retaining clips. Install the assist handle by installing 2 screws and washers into the retaining clips. In replacing the entire coat hook assembly, press the coat hook and the retaining clip as an assembly into the sheet metal opening until the clip locks into position.
By BobGM Specialist
20/02/2022 Q: What is the installation procedure for the Front Side Door Inside Handle?
A:
Install the lock cables to the inside door handle. Insert the inside door handle retaining tabs. Slide the inside door handle forward until the door handle retainers are fully engaged. Install the water deflector. Install the front door trim panel.
By OmarGM Specialist
18/02/2022 Q: What is the installation procedure for the Rear Side Door Outside Handle?
A:
Install the rear outside door handle to the rear door. Install the bolts retaining the rear outside door handle to the door. Connect the rear outside door handle rod to the door handle. Install the rear door water deflector. Install the rear inside door handle. Install the rear door speaker. Install the rear door trim panel.
By BobGM Specialist
16/02/2022 Q: What is the recommended bolt torque for the bolts retaining the rear outside door handle to the door?
A:
The recommended bolt torque is 9 N.m (80 lb in).
By BobGM Specialist
16/02/2022 Q: What is the removal procedure for the Assist Handle?
A:
Pull down the assist handle to reveal the 2 service holes. Remove the screws and washers securing the assist handle to the retaining clip. Remove the assist handle.
By OmarGM Specialist
14/02/2022 Q: What is the removal procedure for the Front Side Door Inside Handle?
A:
Remove the front door trim panel and the water deflector. Slide the inside door handle rearward to release the retaining tabs from the door's inner panel. Remove the lock cables from the inside door handle. Remove the inside door handle.
By BobGM Specialist
12/02/2022 See more FAQs (1)