Part Description: 2008 Chevrolet Colorado Ignition Coil
More Info
Vehicle Fitment
2008 Chevrolet Colorado | All Trims | 4 Cyl 2.9L
2008 Chevrolet Colorado | All Trims | 5 Cyl 3.7L
FAQ for Ignition Coil Repair
Q: What is the installation procedure for the Ignition Coil?
A:
Install the ignition coils into the camshaft cover. Install the ignition coil bolts. Connect the engine wiring harness electrical connectors to the ignition coils. Install the air cleaner resonator and outlet duct.
By Bob
GM Specialist
18/02/2022
Q: What is the recommended bolt torque for the ignition coil bolts?
A:
The recommended bolt torque is ignition coil bolts.
By Omar
GM Specialist
15/02/2022
FAQ for Other Repair Info
Q: What is the installation procedure for the Ignition Lock Cylinder Case?
A:
Install the Ignition Lock Cylinder case. Install the ignition lock cylinder case bolt and tighten it until the head shears off. Install the multifunction turn signal switch. Install the ignition lock cylinder.
Q: What is the installation procedure for the Engine Control Module?
A:
Install the ECM into the ECM mounting bracket. Connect the ECM harness connectors. If a new ECM is being installed, the ECM must be programmed. If equipped with a manual transmission, perform the clutch pedal position sensor learn procedure.
Q: What is the installation procedure for the Knock Sensor?
A:
Install the KS and the retaining bolt to the engine block, positioning the electrical terminals down. Connect the engine wiring harness electrical connector to the KS. Lower the vehicle.