< Back ×
My Vehicle Change Vehicle
2008 Chevrolet Colorado
< Back to View All
Transmissions Components & Shifters
- Department
- Prices
OEM (Genuine) 2008 Chevrolet Colorado Automatic Transmission Range Selector Lever Cable Assembly
PartNumber: 25800701
Product Specifications- Notes: Canyon, Colorado; W/O 5.3l
- Other Names: Shift Control Cable
- Item Dimensions: 15.3 x 15.8 x 6.1 inches
- Item Weight: 2.20 Pounds
- Fitment Type: Direct Replacement
- Replaces: 15867641, 15124555
- Part Description: 2008 Chevrolet Colorado Automatic Transmission Range Selector Lever Cable Assembly
Vehicle Fitment- 2008 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS
$68.60 MSRP:$119.41You Save: $50.81 (43%)
FAQ for Automatic Transmission Shifter Cable Repair
Q: What is the installation procedure for the Range Selector Lever Cable Bracket?
A:
Position the transmission range selector cable bracket to the transmission. Install the transmission range selector cable bracket bolts. Connect the fuel hose/pipe retainer (4) to the range selector cable bracket. Connect the transmission vent hose retainer (6) to the range selector cable bracket. Install the range selector cable (3) to the bracket (2). Install the retainer (4) to the range selector cable (3). Adjust the automatic transmission range selector cable.
By Omar
GM Specialist
17/02/2022Q: What is the installation procedure for the Range Selector Lever Cable?
A:
Push the range selector cable down through the floor panel and seat the cable grommet. Route the range selector cable through the dash mat. Connect the range selector cable retainer to the lower dash panel. Install the range selector cable to the steering column bracket. Install the retainer to the range selector cable. Push the range selector cable end onto the range selector lever ball stud to secure. Reposition the driver's side carpet to the floor panel. Inspect the accelerator pedal for binding, to ensure the full range of motion. Install the left hinge pillar trim panel. Raise and support the vehicle. Install the range selector cable to the bracket. Install the retainer to the range selector cable. Remove and discard the primary lock lockout pin if a new cable is being installed. Adjust the automatic transmission range selector cable. Lower the vehicle.
By Bob
GM Specialist
17/02/2022Q: What is the recommended bolt torque for the transmission range selector cable bracket bolts?
A:
The recommended bolt torque is 25 N.m (18 lb-ft).
By Bob
GM Specialist
14/02/2022Q: What should be done before servicing the Range Selector Lever Cable?
A:
Ensure that the range selector cable is not restricted and the column shift control is in the PARK position.
By Bob
GM Specialist
10/02/2022Q: What should you do before servicing the Range Selector Lever Cable?
A:
Ensure the vehicle is in the park position. Raise and support the vehicle.
By Omar
GM Specialist
09/02/2022