Part Description: 2008 Chevrolet Aveo Motor Asm, Blower (W/ Impeller)
More Info
Vehicle Fitment
2008 Chevrolet Aveo | Base, LS, LT, Special Value | 4 Cyl 1.6 L GAS
FAQ for Blower Motor Repair
Q: How to remove the blower motor?
A:
The proper way is to disconnect the negative battery cable, remove the blower cooling hose, remove the screws that secure the motor to the heater/air distribution case, and then remove the motor and the seal from the heater/air distribution case by gently pulling the motor straight down and out.
By Bob
GM Specialist
01/11/2022
Q: How to install the blower motor?
A:
The proper way is to install the blower motor and seal, install the screws to secure the blower motor to the heater/air distribution case, install the blower motor cooling hose, and then connect the negative battery cable.
By Bob
GM Specialist
01/11/2022
Q: How to install the blower motor relay?
A:
The proper way is to align the relay contacts with the relay terminal slots, replace the instrument panel access panel, replace the remote mirror/lighting control panel, and then connect the negative battery cable.
By Bob
GM Specialist
28/10/2022
Q: How to remove the blower motor relay?
A:
The proper way is to disconnect the negative battery cable, remove the instrument panel fuse cover, and then pull out the relay at the front of the relay box.
By Bob
GM Specialist
28/10/2022
FAQ for Other Repair Info
Q: How to install the heater core?
A:
The proper way is to install the Heater Core into the case, install the heater core cover, install the heater/air distribution case, and then install the instrument panel assembly.
Q: How to install the heater hose assembly?
A:
The proper way is to install the left Heater Hose to the coolant inlet line fitting, install the right heater hose to the fitting below the intake manifold, install and seat the other end of each heater hose, and then inspect the hoses for leaks.
Q: How to install the compressor control valve assembly?
A:
The proper way is to install the control valve assembly, install the control valve retaining ring using J 5403, and then recover the refrigerant.