FAQ for Pillar Panels Repair
Q: How to remove the Rear Compartment Side Trim-Left Side?
A:
You should remove the sill plate, the floor trim plate, the push-in retainer, and the left-hand trim panel from the rear compartment.
By BobGM Specialist
02/11/2022 Q: How to install the Roof Bar Tube Trim?
A:
You should install the roof bar tube assembly to the tube receiver, the roof bar tube retaining bolts, the retaining bolt foam plugs, and the roof bar tube trim, and tuck the remaining trim down between the roof bar tube and the rear window panel trim.
By BobGM Specialist
02/11/2022 Q: How to remove the Front Floor Kick-Up Panel?
A:
You should remove the passenger floor mat from the floor and disengage the kick-up panel by folding the panel down to the floor.
By BobGM Specialist
02/11/2022 Q: What should be noted in the replacement of the Rear Window Panel Trim?
A:
You should remove the seat belt trim bezel from the rear window, leave the bezel on the seat belt, lift upward to slide trim out from behind the end of the console, and route seat belts from both ends.
By BobGM Specialist
02/11/2022 Q: What is the recommended torque for the retaining bolts to secure the molding to the folding top?
A:
The recommended torque is 2.5 N.m (22 lb in).
By BobGM Specialist
02/11/2022 Q: How to remove the Rear Compartment Stowage Tray Net?
A:
You should remove the compartment net attachments from the body side retaining pins, slip the elastic cord loop from the pin and remove the stowage tray net from the vehicle.
By BobGM Specialist
02/11/2022 Q: How to install the Front Floor Kick-Up Panel?
A:
You should lift the kick-up panel and press the panel into place and install the passenger floor mat.
By BobGM Specialist
02/11/2022 Q: How to remove the Body Hinge Pillar Trim Panel?
A:
You should remove the fastener attaching the top of the upper trim panel and the windshield side garnish molding to the hinge pillar, unsnap the upper trim from the hinge pillar, and remove the upper trim and the lower hinge pillar trim if needed.
By BobGM Specialist
02/11/2022 Q: How to remove the Rear Window Lower Garnish Molding?
A:
You should remove the rear window retaining bolts which secure the lower molding to the folding top, and the lower molding out of the rear compartment.
By BobGM Specialist
02/11/2022 Q: How to install the Body Lock Pillar Trim Panel?
A:
You should install the lock pillar trim, push on the trim to engage the retainers, position the seat fully rearward and install the door sill plate.
By BobGM Specialist
02/11/2022 See more FAQs (56)