2008 Cadillac XLR Fuel Tank Pressure Sensor

You should remove the front section of the supercharger inlet duct assembly, the supercharger inlet absolute pressure (SCIAP), the barometric pressure (BARO) and the manifold absolute pressure (MAP) sensors with the bracket, the front section of the charge air cooler front manifold assembly, the ground wire from the right rear injector rail bolt, the oxygen sensor electrical connector assemblies from the right side fuel rail brackets, the oxygen sensor electrical connector assemblies from the left side fuel rail brackets, the fuel rail attaching studs, the injector lower O-ring seal from the spray tip end of each injector, the retainers from the Fuel Injectors if fuel injector removal is necessary, the fuel injectors from the fuel rail, and the O-ring seals from the fuel injectors.

You should install the Fuel Level Sensor wires to the internal connector in the proper location, and the fuel level sensor to the fuel tank module by sliding it down until the lock tab clicks, and ensure that the wires are in the slot below the sensor and the sensor is installed properly.

The recommended torque is 3.5 N.m (31 lb in).