< Back ×
My Vehicle Change Vehicle
2008 Cadillac STS
< Back to View All
Rocker Panels & Floors
- Department
- Prices
OEM (Genuine) 2008 Cadillac STS Rear Floor Pan
PartNumber: 88891833
Product Specifications- Other Names: Rear Floor Pan
- Item Dimensions: 60.9 x 39.3 x 11.6 inches
- Item Weight: 18.50 Pounds
- Fitment Type: Direct Replacement
- Part Description: 2008 Cadillac STS Rear Floor Pan
Vehicle Fitment- 2008 Cadillac STS | Base, Platinum, V | 6 Cyl 3.6 L GAS, 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
$831.31 MSRP:$1254.13You Save: $422.82 (34%)
FAQ for Floor Pan Repair
Q: What should be noticed when eliminating unwanted odors in vehicles?
A:
This product leaves no residual scent and you should not be used it as an air freshener.
By Bob
GM Specialist
29/10/2022Q: What tool is required in the Replacement procedure for Front Carpet Retainer?
A:
J38778 Door Trim Pad Clip Remover is required in the Replacement procedure for Front Carpet Retainer.
By Bob
GM Specialist
29/10/2022Q: What tool is required in the procedure for eliminating unwanted odors in vehicles?
A:
GM Vehicle Care Odor Eliminator, GM P/N 12378554 (Canadian P/N 88901678), is required when eliminating unwanted odors in vehicles.
By Bob
GM Specialist
29/10/2022Q: What is the removal procedure for the Front Carpet Retainer?
A:
The procedure is to release the retainer clips from the rocker panel, slide the carpet retainer rearward from the hinge pillar, disconnect the front carpet retainer from the center pillar garnish molding, remove the front carpet retainer, turn the plastic retainers 90 degrees in the hole to secure if the clips come out of the carpet retainers.
By Bob
GM Specialist
29/10/2022Q: How to dry floor carpet?
A:
If you observe puddles of liquid on the carpet face, you should use a wet vacuum to remove the excess moisture, blot the face of the carpet with a towel to absorb as much moisture as possible, point a fan at the affected area, and air dry the carpet.
By Bob
GM Specialist
29/10/2022Q: How to remove the Rear Carpet Retainer?
A:
The procedure is to Remove the rear seat cushion, release the retainer clips from the rocker panel, lift the rear carpet retainer at the center pillar base, tilt the carpet retainer inward and pull downward, remove the rear carpet retainer, turn the retainer clips 90 degrees in the slot to secure.
By Bob
GM Specialist
29/10/2022Q: What should be noticed in the installation procedure for Front Floor Panel Carpet?
A:
You should use the same thickness and material size as the original installation to avoid personal injury or vehicle damage when you repair or replace the carpet and always return the carpet to the original location.
By Bob
GM Specialist
29/10/2022Q: What is the installation procedure for the Front Floor Panel Carpet?
A:
The procedure is to position the front floor carpet into place over the front edge of the rear carpet, make sure the electrical connector is carefully positioned under the front carpet piece, align the carpet to the dash panel, rocker panel, tunnel, and seat attachment areas, tuck the carpet behind the tab on the HVAC duct, ensure all wrinkles are removed, install the center console, install the center pillar garnish molding, install the front carpet retainer, install the rear carpet retainer, install the front seat.
By Bob
GM Specialist
29/10/2022Q: How to install the Rear Carpet Retainer?
A:
The procedure is to position the rear carpet retainer with the slots in the rocker, tilt the trim plate, ensure the rear carpet retainer is aligned at the lower lock pillar trim, position the retainers into the slots on the rocker panel, align the carpet retainer to the slot on the center trim pillar, press downward to engage the retainers into the slots in the rocker panel, install the rear seat cushion.
By Bob
GM Specialist
29/10/2022Q: What is the installation procedure for the Front Carpet Retainer?
A:
The procedure is to position the front upper retainer to the holes in the hinge pillar, align the front carpet retainer with the slots in the rocker panel, apply pressure along the entire length of the molding to secure the retainers, ensure the fit at the lower center pillar garnish molding is secure to the front carpet retainer.
By Bob
GM Specialist
29/10/2022See more FAQs (7)