2008 Cadillac SRX Window Regulator

You should raise the window to the full-up position, remove the door trim panel and the water deflector, tape the window in the full-up position, connect the door trim panel wire harness connector, loosen the window regulator to the window clamp nuts 4 revolutions, lower the window regulator about 1/2 way down, disconnect the electrical connector from the power window motor and remove the window regulator bolts and the window regulator through the rear access hole in the door panel.

You should install the window regulator into the door and the window regulator bolts, remove the support from the window, lower the window into the window regulator clamps, connect the power window motor electrical connector, start the vehicle, raise the window to the full up position, inspect the window for proper operation and fit, shut off the vehicle, install the water deflector and the door trim panel and reprogram the power window regulator.