Contact Us Live Chat or 1-888-220-8330
Search Bar
Search by Part Number or Keywords
  • My Garage
  • My Account
  • Cart
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Help Center
< Back ×
  • Body & Mirrors
  • Chassis & Brakes
  • Engine & Drivetrain
  • Electrical & Lighting
Login/Register My Account Track Order Help Center Contact Us
Replacement and OEM Parts for 2008 Cadillac SRX Rack and Pinion Seal

2008 Cadillac SRX Rack and Pinion Seal

My Vehicle Change Vehicle
2008 Cadillac SRX
Change Vehicle
Vehicle Options
We need more information about your vehicle to make a correct determination of fitment
< Back to View All
Steering Racks & Gearboxes
  • Department
  • Brands
  • Prices

1 Product found

2 Q&A for Rack And Pinion Seal Repair
Show Item:
  • 30
  • 60
  • 90
Sort by:
Recommended
Filter
Sort
View by

FAQ for Rack And Pinion Seal Repair

Q: How to remove the Drive Pinion Flange/Yoke and/or Oil Seal (V8 Engine)?
A:
You should raise and support the vehicle, remove the exhaust system, reference mark the propeller shaft constant velocity (CV) joint to the drive pinion flange, remove the propeller shaft CV joint-to-drive pinion flange bolts, push the propeller shaft toward the front of the vehicle to release the propeller shaft from the drive pinion flange, position the propeller shaft aside and support with heavy mechanics wire or equivalent, install the J 45012 to the drive pinion flange, remove the drive pinion nut and J 45012 from the drive pinion flange, install the J 45019 to the drive pinion flange, remove the drive pinion flange, the J 45019 from the drive pinion flange and the drive pinion seal.
By Bob
GM Specialist
02/11/2022
Q: How to remove the Drive Pinion Flange/Yoke and/or Oil Seal (V6 Engine)?
A:
You should raise and support the vehicle, remove the exhaust system and the propeller shaft, install the J 45012 to the flange, remove the drive pinion nut using J 34826 while holding the J 45012, remove the J 45012, install the J 45019 to the flange, remove the flange, use a flat-bladed tool to remove the drive pinion seal and take care not to damage any sealing surfaces.
By Bob
GM Specialist
02/11/2022

FAQ for Other Repair Info

Q: How to install the Steering Gear (Right Hand Drive)?
A:
You should install the steering gear and the rearward left side lower control arm nut and bolt, remove the steering gear bolts, lower the front differential housing, remove the jack, connect the left front brake line to the left front brake hose and the power steering gear inlet and outlet hoses to the steering gear, install the power steering gear inlet hose bracket bolt, connect the rack and pinion outer tie rod ends to the steering knuckles and the lower intermediate steering shaft to the steering gear, install the lower intermediate steering shaft bolt, clean any excess power steering fluid from the vehicle and remove the drain pans, install the front air deflector, the right side wheelhouse panel and the front tire and wheel assemblies, remove the anti-rotation pin J 42640, fill and bleed the power steering system and the hydraulic brake system and adjust the front toe.