< Back ×
My Vehicle Change Vehicle
2008 Cadillac SRX
< Back to View All
Door Handles, Locks & Related Parts
- Department
- Prices
OEM (Genuine) 2008 Cadillac SRX Lift Gate
PartNumber: 15828682
Product Specifications- Other Names: Lift Gate
- Item Dimensions: 49.0 x 11.5 x 62.9 inches
- Item Weight: 39.80 Pounds
- Fitment Type: Direct Replacement
- Replaces: 15254242, 15211325
- Part Description: 2008 Cadillac SRX Lift Gate
Vehicle Fitment- 2008 Cadillac SRX | Base | 6 Cyl 3.6 L GAS, 8 Cyl 4.6 L GAS
$803.02 MSRP:$1211.44You Save: $408.42 (34%)
FAQ for Liftgates Repair
Q: What is the recommended torque for the Liftgate Close Actuator Motor Control Module Bolt?
A:
The recommended torque is 9 Nm (80 lb in).
By Bob
GM Specialist
01/11/2022Q: How to remove the Liftgate Window?
A:
You should open the liftgate, remove the liftgate trim panel and the rear wiper motor, disconnect the rear window defogger connector, and make sure that if the broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury and cover to protect the upper dash pad, the defroster outlets and A/C outlets and the seats and carpeting from broken glass, separate the urethane adhesive from the window and use the suction cups to lift the liftgate window from the opening.
By Bob
GM Specialist
01/11/2022Q: How to replace the Liftgate Close Actuator Motor Control Module?
A:
You should remove the body side trim panel, disconnect the power liftgate actuator rod, disconnect the electrical connector, and cut the tie strap if equipped. If a replacement control module is installed, you should program the module.
By Bob
GM Specialist
01/11/2022Q: How many plastic retainers attach to the Liftgate Side Upper Sensor?
A:
There are 4 plastic retainers attaching the liftgate side upper sensor.
By Bob
GM Specialist
01/11/2022Q: How to replace the Liftgate Side Upper Sensor?
A:
You should remove the liftgate trim panel and disconnect all electrical connectors as needed.
By Bob
GM Specialist
01/11/2022Q: How many bolts attach to the Liftgate Close Actuator Motor Control Module?
A:
There are 5 bolts attaching the liftgate close actuator motor control module.
By Bob
GM Specialist
01/11/2022Q: How to remove the Liftgate Outside Handle?
A:
You should remove the liftgate applique, the nuts retaining the handle to the liftgate and the handle from the liftgate, disconnect the latch actuator cable from the handle and remove the liftgate handle.
By Bob
GM Specialist
01/11/2022Q: How to install the Liftgate Outside Handle?
A:
You should connect the latch actuator cable to the handle, install the liftgate handle to the liftgate, the nuts that retain the handle to the liftgate and the liftgate applique, center the handle in the opening in the liftgate applique, and tighten the nuts retaining the liftgate handle to the liftgate.
By Bob
GM Specialist
01/11/2022See more FAQs (3)