2008 Cadillac SRX Door Lock Cylinder

You should remove the door trim panel, pull back the forward half of the water deflector from the door panel to access the check link, and remove the Door Check link to body bolt, the check link to the door nuts, and the check link from the door.

The recommended torque is 25 Nm (18 lb-ft).

You should raise the window to the full up position, remove the door trim panel and the water deflector, disconnect the lock cylinder rod from the door latch and the outside door handle rod from the door latch by opening the clip, remove the lock knob rod from the rod guide, the inside handle rod from the rod guide, the door latch screws and the door latch from the door with the inside door handle rod and lock rod attached, use a small flat-bladed tool to lift the electrical connector lock, disconnect the electrical connector and remove the handle rod and lock rod from the door latch.