2008 Cadillac SRX Air Filter

You should carefully clean the Throttle Body mounting surfaces of any gasket and/or seal material, install the throttle body and new gasket, the throttle body bolts, the wiring harness conduit, the throttle body electrical connector, and the air cleaner intake duct, perform the throttle learn procedure and clear all diagnostic trouble codes.

You should turn the ignition off, remove the fuel injector sight shield and the air inlet duct, disconnect the brake booster vacuum hose from the Intake Manifold, the purge solenoid valve electrical connector, and the purge line, remove the wiring harness retainer, disconnect the throttle body electrical connector, remove the upper intake manifold brace stud, bolt, and brace, disconnect the positive crankcase ventilation (PCV) hose, the barometric pressure sensor electrical connector, and the intake manifold runner control solenoid electrical connector, remove the injector harness bracket bolt, the left bank ignition coil wiring harness from the bracket, the upper intake manifold bolts and the upper intake manifold with the throttle body and clean and inspect the intake manifold.

You should raise and support the vehicle, twist the air tube seal connection on the rear shocks, disconnect the air tube from the rear shock absorber and the exhaust system from the rear exhaust hangers, remove the automatic level control compressor with the bracket attached, disconnect the air tube from the right wheel house liner clip and remove the wheelhouse liner screw to position the liner to access the air tube, the air tube from the frame at the right wheel house liner, the fuel filler neck bolt and reposition the air tubes and the air tubes from the vehicle.