Other Names: Fuel Gauge Sending Unit, Level Sensor
Item Dimensions: 5.1 x 3.2 x 10.3 inches
Item Weight: 0.50 Pounds
Fitment Type: Direct Replacement
Replaces: 19180802, 19168705
Part Description: 2008 Cadillac Escalade ESV Fuel Gauge Sending Unit
More Info
Vehicle Fitment
2008 Cadillac Escalade ESV | Base, Platinum | 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
$87.06MSRP: $157.58
You Save: $70.52 (45%)
FAQ for Fuel Level Sensor Repair
Q: How to remove the Fuel Level Sensor?
A:
You can remove the fuel tank module, disconnect the fuel level sensor electrical connector, release the fuel level sensor retaining clip, and slide the fuel level sensor down off of the bucket.
By Bob
GM Specialist
01/11/2022
Q: How to install the Fuel Level Sensor?
A:
You can slide the fuel level sensor up onto the bucket until the sensor engages the retaining tab, connect the fuel level sensor electrical connector, and install the fuel tank module.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to remove the Fuel Pressure Sensor/Switch?
A:
You can wrap a shop towel around the Fuel Pressure Sensor fitting to absorb any fuel that may leak out, remove the fuel pressure sensor, and discard the fuel pressure sensor O-ring seal.
Q: What should I notice for Gasoline/Gasoline Vapors?
A:
Gasoline or gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or diesel fuel in an open container, due to the possibility of fire or explosion.
Q: How to install the Fuel Tank Pressure Sensor?
A:
You can lubricate the seal on the fuel pressure sensor, press the fuel pressure sensor into the line, and install the intermediate fuel and EVAP lines.