FAQ for Brake Hose Repair
Q: What is the recommended torque for the brake hose fitting bolt?
A:
The recommended torque is 49Nm(36 lb-ft).
By BobGM Specialist
01/11/2022 Q: What kind of special tool is needed in the process of brake pipe replacement?
A:
You need to use the J 45405 Pipe Flaring Tool Kit.
By BobGM Specialist
01/11/2022 Q: What is the installation procedure for the rear brake hose?
A:
First, you need to assemble the brake hose fitting bolt with 2 new brake hose fitting gaskets to the brake hose. Then, please install the brake hose assembly to the caliper, install the rear brake hose retainer clip, and connect the rear brake pipe fitting. Finally, you should bleed the hydraulic brake system and install the tire and wheel assembly.
By BobGM Specialist
01/11/2022 Q: What are the recommended torque for the intermediate brake hose assembly mounting nuts, the brake hose fitting bolt, and the crossover brake pipe fitting?
A:
The recommended torque is 10Nm(89 lb in), 49Nm(36 lb ft), and 18Nm (13 lb ft) respectively.
By BobGM Specialist
01/11/2022 Q: What is important when installing the pipe?
A:
You should maintain a clearance of 19 mm (3/4 in) from all moving or vibrating components.
By BobGM Specialist
01/11/2022 Q: What should you do after disconnecting the crossover brake pipe fitting from the intermediate brake hose assembly?
A:
You should cap the brake pipe fitting to prevent brake fluid loss and contamination.
By BobGM Specialist
01/11/2022 Q: What should be paid attention to in the process of brake pipe replacement?
A:
You should ensure that the brake pipe end to be flared is cut at a square, 90-degree angle to the pipe length and that all loose remnants of the nylon coating have been removed from the brake pipe.
By BobGM Specialist
01/11/2022 Q: What is the removal procedure of the rear brake hose?
A:
First, you need to remove the tire and wheel assembly and disconnect the rear brake pipe fitting. Then, please remove the front brake hose retainer clip, the brake hose fitting bolt, and the brake hose fitting gaskets. Finally, you should discard the brake hose fitting gaskets and remove the brake hose.
By BobGM Specialist
01/11/2022 Q: What should be ensured after the installation procedure of the brake intermediate hose?
A:
You should make sure the brake hose is not twisted or kinked after installation.
By BobGM Specialist
01/11/2022 See more FAQs (4)