2008 Cadillac CTS Body Control Module

First, you need to install the Starter heat shield bracket to the stud located at the engine block, install the nut securing the starter heat shield bracket to the engine block, install the starter heat shield bracket to the stud located at the rear of the starter motor and install the nut securing the starter heat shield bracket to the starter. Then, please position the starter heat shield to the starter motor and brackets. Finally, you should install the bolt/nuts securing the starter heat shield to the starter motor and brackets, install the right catalytic converter, and connect the battery negative cable.

First, you need to apply structural adhesive epoxy, Lord Fusor(TM) 127EZ or equivalent, to the fascia at the mating surface. Then, please use the alignment tabs to install the sensor housing to the fascia and allow the adhesive to cure according to the manufacturer's directions. Finally, you should install the sensor to the sensor housing and connect the electrical harness and install the rear fascia.

First, you need to clean any dirt or debris from the grommet sealing area and insert the sensor in the wheel hole with the air passage facing away from the wheel, install the sensor nut and position the sensor body parallel to the inside wheel surface while tightening. Then, please install the tire on the wheel and install the tire/wheel assembly on the vehicle. Finally, you should lower the vehicle and learn the tire pressure sensors.