Part Description: 2008 Buick Lucerne Motor Asm-Mode Valve Actuator
More Info
Vehicle Fitment
2008 Buick Lucerne | CX, CXL, CXL Special Edition, CXS, Super | 6 Cyl 3.8 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 4.6 L GAS
FAQ for Hvac Heater Blend Door Actuator Repair
Q: What is the recirculation actuator service procedure?
A:
Remove the HVAC module and disconnect the recirculation actuator electrical connector. Tighten the recirculation actuator screws to 1.0 Nm.
By Bob
GM Specialist
01/11/2022
Q: What is the temperature valve actuator service procedure?
A:
First, remove the HVAC module assembly and the right-hand floor air outlet duct. Remove the left-hand floor air outlet duct and disconnect the HVAC module electrical connector. Tighten the A/C evaporator case upper screws to 1.0 Nm.
By Bob
GM Specialist
01/11/2022
Q: What is the mode actuator service procedure?
A:
First, remove the instrument panel lower trim panel, and the floor air outlet duct. Next disconnect the mode actuator electrical connector. Tighten the mode actuator screws to 1.0 Nm.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the ambient air temperature sensor service procedure?
A:
First, remove the front compartment sight shield and disconnect the ambient Air Temperature Sensor electrical connector. Make sure to squeeze the three ambient temperature sensor tabs to release the sensor from the bracket.
Q: What is the blower motor service procedure?
A:
First, remove the right-hand closeout insulator panel and disconnect the Blower Motor electrical connector. Tighten the blower motor screws to 1.0 Nm.
Q: What is the blower motor resistor service procedure?
A:
Remove the right-hand closeout insulator and disconnect the Blower Motor Resistor electrical connector. Tighten the motor resistor screw to 1.0 Nm.