Material: Green Rubber O-Rings, Black Aluminum Gaskets
Style: O-Ring & Gasket Kit
UPC: 096361268043
Part Description: 2008 Buick Lucerne A C System O Ring And Gasket Kit
More Info
Vehicle Fitment
2008 Buick Lucerne | All Trims | All Engines
$16.07
FAQ for A/C System Seal Kit Repair
Q: What is the sealing washer removal procedure?
A:
First, remove the seal washer from the A/C refrigerant component, and inspect the seal washers and the A/C refrigerant. Next, discard the sealing washers,.
By Bob
GM Specialist
28/10/2022
Q: What is the sealing washer installation procedure?
A:
Inspect the new seal washer for any signs of damage and remove the cap/tape from the A/C refrigerant components. Install the new seal washer onto the A/C refrigerant component.
By Bob
GM Specialist
28/10/2022
Q: What is the O-ring installation procedure?
A:
First, inspect the new O-ring seals for any signs of damage and remove the cap/tape from the A/C refrigerant components. Next coat the new O-ring seals with mineral base 525 viscosity refrigerant oil and slide the new O-ring seals onto the A/C refrigerant component.
By Bob
GM Specialist
28/10/2022
FAQ for Other Repair Info
Q: What is the ambient air temperature sensor service procedure?
A:
First, remove the front compartment sight shield and disconnect the ambient Air Temperature Sensor electrical connector. Make sure to squeeze the three ambient temperature sensor tabs to release the sensor from the bracket.
Q: What is the blower motor service procedure?
A:
First, remove the right-hand closeout insulator panel and disconnect the Blower Motor electrical connector. Tighten the blower motor screws to 1.0 Nm.
Q: What is the blower motor resistor service procedure?
A:
Remove the right-hand closeout insulator and disconnect the Blower Motor Resistor electrical connector. Tighten the motor resistor screw to 1.0 Nm.