Part Description: 2008 Buick LaCrosse Ignition Knock Sensor
More Info
Vehicle Fitment
2008 Buick LaCrosse | All Trims | 6 Cyl 3.8L
$36.03
FAQ for Knock Sensor Repair
Q: How do you install the knock sensor?
A:
You can install the knock sensor, connect the electrical connector, and fill up the cooling system.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the knock sensor?
A:
The procedure is to drain the cooling system, disconnect the electrical connector, and remove the knock sensor.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the ignition coil installation procedure?
A:
Install the Ignition Coil bolts and tighten the bolts to 8 Nm. Install the spark plug wires to the ignition coils, connect the left ignition coil main electrical connector, install the CPA retainer and install the engine sight shield.
Q: What is the proper way to install the ignition lock cylinder case?
A:
The proper way is to install the turn signal switch housing, the steering column tilt head, and the Ignition Lock Cylinder.
Q: What is the engine control module installation procedure?
A:
First, start by installing the ECM to the air cleaner lower housing. Connect the ECM electrical connectors and install the air cleaner assembly. Install the left front inner fender brace and connect the negative battery cable.