< Back ×
My Vehicle Change Vehicle
2008 Buick Enclave
< Back to View All
Cameras & Driver Safety
- Department
- Prices
OEM (Genuine) 2008 Buick Enclave Reverse Sensor
PartNumber: 15239247
Product Specifications- Notes: Enclave, Traverse; 2008-2012
- Other Names: Alarm, Park Sensor, Reverse Sensor, Sensor
- Item Dimensions: 4.8 x 2.3 x 1.9 inches
- Item Weight: 0.30 Pounds
- Fitment Type: Direct Replacement
- Replaces: 19116085
- Part Description: 2008 Buick Enclave Reverse Sensor
Vehicle Fitment- 2008 Buick Enclave | Base, Convenience, CX, CXL, Leather, Premium | 6 Cyl 3.6 L GAS
$155.45 MSRP:$244.48You Save: $89.03 (37%)
FAQ for Parking Sensors Repair
Q: How do you install the Rear Object Sensor?
A:
You need to paint the rear object sensor, use a paint thickness gauge suitable for non-ferrous metals, insert the sensor into the housing, connect the electrical connector to the rear object sensor, and then install the rear bumper fascia.
By Bob
GM Specialist
02/11/2022Q: How do you remove the Parking Aid Monitor Module?
A:
You need to pull the tabs outward to release the module from the bezel.
By Bob
GM Specialist
02/11/2022Q: How do you replace the Rear Object Sensor Housing?
A:
You need to remove the rear fascia, disconnect the sensor harness, remove the sensor from the sensor housing, sand/grind sonic weld plastic residue from the fascia, apply structural adhesive epoxy, Lord Fusor(TM) 127EZ or equivalent, to fascia at the mating surface, install the sensor housing to the fascia, allow adhesive to cure according to manufacturer's directions, install the sensor to the sensor housing, connect the electrical harness, and then install the rear fascia.
By Bob
GM Specialist
02/11/2022Q: How do you remove the Rear Object Sensor?
A:
You need to remove the rear bumper fascia, disconnect the electrical from the rear object sensor, and then lift the locking tabs on the housing and remove the rear object sensor.
By Bob
GM Specialist
02/11/2022Q: What will need to be done before replacing the Object Alarm Module?
A:
You will need to remove the left rear quarter lower trim panel and the liftgate actuator.
By Bob
GM Specialist
01/11/2022Q: How do you remove the Object Alarm Module?
A:
You need to disconnect the body harness from the bracket, loosen the bracket fasteners to remove the bracket from the slotted holes, and then disconnect the electrical connectors.
By Bob
GM Specialist
01/11/2022Q: How do you replace the Information Center Telltale Assembly Bezel?
A:
You will need to position a flat-bladed plastic trim tool between the headliner and the rear of the information center telltale assembly bezel to release the tab retaining the bezel to the headliner, and then release the electrical connector.
By Bob
GM Specialist
01/11/2022See more FAQs (2)