FAQ for Shock Absorber Repair
Q: What is the recommended torque for the front shock absorber nuts?
A:
The recommended torque is 60 N.m (44 lb-ft).
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the shock absorber module?
A:
The recommended torque is 50 N.m (37 lb-ft).
By BobGM Specialist
01/11/2022 Q: How many bolts attach to the Shock Absorber Module?
A:
There are 2 bolts attaching the Shock Absorber Module.
By BobGM Specialist
01/11/2022 Q: What should be done to replace the shock absorber?
A:
You should remove the shock module, collapse the front suspension spring, and then use a wrench to the shock absorber shaft to prevent it from rotating.
By BobGM Specialist
01/11/2022 Q: What should be done to prevent personal injury?
A:
Gas-charged shock absorbers contain high-pressure gas. You should not remove the snap ring from inside the top of the tube. If the snap ring is removed, the contents of the shock absorber will come out with extreme force which may result in personal injury. To prevent personal injury, you should wear safety glasses when centerpunching and drilling the shock absorber. You should use care not to puncture the shock absorber tube with the center punch.
By BobGM Specialist
01/11/2022 Q: What should be noted for the Right Rear Shock Absorber?
A:
When performing a service regeneration on cab chassis vehicles, you should remove the right rear shock absorber to prevent damage to the component. Failure to remove this component may result in damage to the component.
By BobGM Specialist
01/11/2022 Q: What special tool will I need when servicing the shock absorber?
A:
You will need a strut spring compressor.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the Shock Absorber Module nuts?
A:
The recommended torque is 50 N.m (37 lb-ft).
By BobGM Specialist
01/11/2022 Q: What should be done before servicing the shock absorber and spring assembly?
A:
You should raise and support the vehicle, remove the front tire and wheel assembly and then disconnect the outer tie rod from the steering knuckle.
By BobGM Specialist
01/11/2022 See more FAQs (4)