Notes: Contents Premium Stainless Hardware Incld; 9900lb GVW; Akebono is the OE Manufacturer; OE Pad Material is Ceramic;Contents Premium Stainless Hardware Incld; 12000lb GVW; OE Pad Material is Ceramic
FMSI: D784
Friction Material: Ceramic
Quantity: Sold as Set
Series: Pro-ACT™ Ultra-Premium
UPC: 821726000866
Part Description: 2007 GMC Sierra 3500 HD Pro-ACT™ Ultra-Premium Ceramic Front Disc Brake Pads
Notes: OE Ceramic;Includes Pad Installation Hardware
Chamfer Option: With Chamfers
FMSI: D784
Friction Material: Ceramic
Hardware Option: Included
Inner Pad Thickness: 17.78mm (0.7")
Outer Pad Thickness: 17.78mm (0.7")
Quantity: Sold as Set
Series: QuickStop®
Shims Option: With Shims
Slot Option: With Slot
UPC: 008536431305
Wear Sensor Option: With Mechanical Wear Sensor
Part Description: 2007 GMC Sierra 3500 HD Quickstop Ceramic Front Disc Brake Pads
More Info
Vehicle Fitment
2007 GMC Sierra 3500 HD | All Trims | All Engines
$32.41
1-30 of 53 Results
< Previous
12
Next >
FAQ for Brake Pad Set Repair
Q: What should be done before servicing the Front Disc Brake Pads?
A:
You should inspect the fluid level on the brake master cylinder reservoir, raise and support the vehicle and then remove the tire and wheel assembly.
By Bob
GM Specialist
01/11/2022
Q: What is the burnishing procedure for the brake pad and rotor?
A:
The procedure is to select a smooth road with little or no traffic, accelerate the vehicle to 48 km/h (30 mph), apply the brakes to bring the vehicle to a stop, and then repeat steps 2 and 3 until approximately 20 stops have been completed.
By Bob
GM Specialist
01/11/2022
Q: What needs to be done before servicing the Rear Disc Brake Pads?
A:
You should inspect the fluid level on the brake master cylinder reservoir, raise and support the vehicle and then remove the tire and wheel assembly.
By Bob
GM Specialist
01/11/2022
Q: How many pads attach to the Disc Brake?
A:
There are 2 pads attaching the Disc Brake.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to assemble the Rear Brake Caliper Overhaul?
A:
You can install the square-cut piston seal in the Brake Caliper bore groove, the boot over the end of the piston, the piston in the bore, the bleeder valve in the brake caliper housing, the bleeder valve cap, and the brake caliper.
Q: What is the burnishing procedure for the brake pad and rotor?
A:
The procedure is to select a smooth road with little or no traffic, accelerate the vehicle to 48 km/h (30 mph), apply the brakes to bring the vehicle to a stop, and then repeat steps 2 and 3 until approximately 20 stops have been completed.