FAQ for Air Bag Sensor Repair
Q: How many bolts attach to the Inflatable Restraint Roof Rail Module?
A:
There are 7 bolts attached to the Inflatable Restraint Roof Rail Module.
By BobGM Specialist
01/11/2022 Q: How many retainers attach to the Inflatable Restraint Roof Rail Module?
A:
4retainers are attaching the Inflatable Restraint Roof Rail Module.
By BobGM Specialist
01/11/2022 Q: How to correct the seat occupant classification module?
A:
The Sensing and Diagnostic Module (SDM) should not be replaced when diagnostic trouble code (DTC) B0081 sets. The SDM sets DTC B0081 only to report that there is no communication with the Passenger Presence System (PPS) module or that the PPS module has reported a fault. It is important that when the B0081 fault is reported by the SDM, the DTCs from the PPS be retrieved and addressed first per the procedure below. After the PPS module DTCs have been addressed, you should turn the ignition off, open the driver's door, and wait 40 seconds for the PPS module to go to sleep.
By BobGM Specialist
01/11/2022 Q: What should be noted for the supplemental inflatable restraint (SIR) instrument panel module disable switch assembly?
A:
You should remove the connector position assurance (CPA) retainer and then disconnect the electrical connector.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the Inflatable Restraint Roof Rail Module?
A:
The recommended torque is 9 N.m (80 lb-ft).
By BobGM Specialist
01/11/2022 Q: What should be noted for the inflatable restraint vehicle rollover sensor?
A:
You should disable the supplemental inflatable restraint (SIR) system, remove the front center floor console bezel assembly and then remove the center seat.
By BobGM Specialist
01/11/2022 Q: How many nuts attach to the inflatable restraint vehicle rollover sensor?
A:
There are 3 nuts attaching the inflatable restraint vehicle rollover sensor.
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the Inflatable Restraint Side Impact Sensor Module bolts?
A:
The recommended torque is 9 N.m (80 lb-ft).
By BobGM Specialist
01/11/2022 Q: What is the recommended torque for the Inflatable Restraint Vehicle Rollover Sensor nuts?
A:
The recommended torque is 10 N.m (88 lb in).
By BobGM Specialist
01/11/2022 Q: What should be done before servicing the Inflatable Restraint Side Impact Sensor?
A:
You should disable the supplemental inflatable restraint (SIR) system, remove the rear side door trim panel and remove the rear side door water deflector.
By BobGM Specialist
01/11/2022 See more FAQs (13)