Part Description: 2007 GMC Sierra 3500 Classic Ignition Coil
More Info
Vehicle Fitment
2007 GMC Sierra 3500 Classic | All Trims | 8 Cyl 6.0L
2007 GMC Sierra 3500 Classic | All Trims | All Engines
FAQ for Ignition Coil Repair
Q: How to install the ignition coil?
A:
The proper way is to install the ignition coil, the ignition coil bolts, and the spark plug wire, connect the ignition coil wiring harness electrical connector to the ignition coil and install the intake manifold sight shield.
By Bob
GM Specialist
01/11/2022
Q: How to remove the ignition coil?
A:
The proper way is to remove the intake manifold sight shield, the spark plug wire from the ignition coil, and the ignition coil from the bracket.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the ignition lock cylinder case?
A:
You shall install the Ignition Lock Cylinder case, and the park lock cable into the lock cylinder housing, the ignition/start switch, and the inflatable restraint steering wheel module coil.
Q: How to install the knock sensor 2?
A:
The proper way is to position the Knock Sensor to the engine block, install the knock sensor bolt, connect the engine wiring harness electrical connector to the knock sensor, and install the right front wheel and tire.
Q: What is the removal procedure for the engine control module?
A:
The procedure is to retrieve the percentage of remaining engine oil, disconnect the negative battery cable, disengage the engine wiring harness upper and lower electrical connector retainers, and remove the connectors from the ECM, and the ECM.