Part Description: 2007 GMC Sierra 3500 Classic Inner Boot
More Info
Vehicle Fitment
2007 GMC Sierra 3500 Classic | SL, SLE, SLT, WT | 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL, 8 Cyl 8.1 L GAS
$27.28MSRP: $43.53
You Save: $16.25 (38%)
FAQ for Cv Joint Boot Repair
Q: What should be noticed while installing the wheel drive shaft outer joint and boot?
A:
You shall make sure that the retaining ring side of the CV joint inner race faces the half-shaft bar before installation.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the small clamp?
A:
The recommended torque is 136 N.m (100 lb-ft).
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the rear axle shaft (8.6-inch axle w/drum brakes non-veses)?
A:
You shall install the Axle Shaft into the rear axle housing, the C-lock, the brake drum, the rear cover and the gasket, and the tire and wheel assembly.
Q: What is the removal procedure for the front axle lubricant?
A:
The proper way is to remove the engine shield, clean the area around the front axle fill plug and the drain plug, remove the fill plug and the drain plug, and drain the fluid from the front Differential carrier assembly.
Q: How to remove the rear axle shaft seal and/or bearing (w/rear disc)?
A:
You shall remove the tire and wheel assembly, the rear axle housing cover, the axle shaft, the Axle Shaft Seal, and the bearing from the axle housing.