Part Description: 2007 Chevrolet Monte Carlo OE Type Oxygen Sensor
More Info
Vehicle Fitment
2007 Chevrolet Monte Carlo | All Trims | 6 Cyl 3.5L
2007 Chevrolet Monte Carlo | All Trims | 8 Cyl 5.3L
$36.71
FAQ for Oxygen Sensor Repair
Q: How do you remove the heated oxygen sensor?
A:
You can remove the CPA retainer, the oxygen sensor electrical connector, and the HO2S.
By Bob
GM Specialist
14/03/2022
Q: What is the installation procedure for the heated oxygen sensor?
A:
The procedure is to re-install the old sensor, install the HO2S, connect the electrical connector, and install the electrical connector for the oxygen sensor.
By Omar
GM Specialist
11/03/2022
Q: What is the proper way to remove the heated oxygen sensor?
A:
The proper way is to remove the CPA retainer, the HO2S electrical connector clip, and the HO2S.
By Bob
GM Specialist
10/03/2022
FAQ for Other Repair Info
Q: How do I install the cabin air filter?
A:
First, place the Cabin Air Filter into the filter housing next you'll need to install the water deflector cover and the air inlet grill panel. Then position the washer hose into the right air inlet grille panel clips. Install the rear hood seal and close the hood. Lastly, put the windshield wipers back in their original position.
Q: How do I install the Camshaft Position Actuator Magnet?
A:
Start with installing the Camshaft Position Actuator Magnet O-ring seal and magnet. Then install the bolts that attach the sensor. Connect the camshaft position actuator magnet sensor to the electrical connector. Lastly, install the manifold intake cover.
Q: How do I install the Drive Belt Idler Pulley?
A:
Start with attaching the required drive belt Idler Pulley, install the drive belt idler pulley bolt, and tighten it to 50 Nm (37 LB-FT). Lastly, install the drive belt.