Part Description: 2007 Chevrolet Monte Carlo Balancer Asm-Crankshaft
More Info
Vehicle Fitment
2007 Chevrolet Monte Carlo | SS | 8 Cyl 5.3 L GAS
FAQ for Harmonic Balancer Repair
Q: What causes the engine compartment to make squealing noises?
A:
The squealing noises may be due to the crankshaft balancer slipping.
By Omar
GM Specialist
11/03/2022
Q: What is the recommended bolt torque for the crankshaft balancer bolt?
A:
The recommended bolt torque is 160 Nm (118 LB-FT).
By Omar
GM Specialist
10/03/2022
Q: What is the recommended bolt torque for the right and left side frame bolts?
A:
The recommended bolt torque is 100 Nm (74 LB ft.) plus an additional 90 degrees.
By Bob
GM Specialist
10/03/2022
Q: What should I avoid using when installing the crankshaft balancer?
A:
It is recommended that the crankshaft balancer and bolt be manually installed. This controls the alignment of the crankshaft balancer.
By Bob
GM Specialist
08/03/2022
Q: What special tools will I be needing when servicing the Crankshaft Balancer?
A:
You will need a puller end protector, balancer and crank sprocket installer, angle meter, flywheel holder, and harmonic balancer.
By Bob
GM Specialist
08/03/2022
FAQ for Other Repair Info
Q: How do I install the Camshaft Position Actuator Magnet?
A:
Start with installing the Camshaft Position Actuator Magnet O-ring seal and magnet. Then install the bolts that attach the sensor. Connect the camshaft position actuator magnet sensor to the electrical connector. Lastly, install the manifold intake cover.
Q: How do I install the Drive Belt Idler Pulley?
A:
Start with attaching the required drive belt Idler Pulley, install the drive belt idler pulley bolt, and tighten it to 50 Nm (37 LB-FT). Lastly, install the drive belt.
Q: How do you remove the drive belt?
A:
You can remove the intake manifold cover, the air cleaner, and the Drive Belt.