Part Description: 2007 Chevrolet Monte Carlo Radiator Pressure Equalizer Hose
More Info
Vehicle Fitment
2007 Chevrolet Monte Carlo | SS | 8 Cyl 5.3 L GAS
FAQ for Coolant Hose Repair
Q: How do I remove the Engine Coolant Crossover Pipe?
A:
Remove the intake manifold cover, the generator, the drive belt idler pulleys, and the power steering pump. Then reposition the coolant recovery reservoir hose clamp. Remove the coolant recovery reservoir hose and move out of the way. Reposition the radiator inlet hose clamp. Remove the radiator inlet hose, the coolant crossover pipe bolts, and the coolant crossover pipe.
By Omar
GM Specialist
15/03/2022
Q: What is the recommended bolt torque for the coolant crossover pipe bolts?
A:
The recommended bolt torque is 50 Nm (37 LB-FT).
By Bob
GM Specialist
10/03/2022
FAQ for Other Repair Info
Q: How do you install the water pump?
A:
You can install the Water Pump pulley, and the drive belt, and fill up the cooling system.
Q: What is the engine coolant thermostat housing installation procedure?
A:
First, place the new gasket and the Thermostat Housing on the engine block. Next, install the thermostat housing bolt/stud and tighten them to 10 Nm. Install the radiator outlet hose to the thermostat housing and place the radiator outlet hose clamp at the thermostat housing. Finally, install the air cleaner outlet duct and fill the cooling system.
Q: What is the thermostat installation procedure?
A:
Install the new Thermostat, and place a new gasket and the thermostat housing on the engine block. Next, install the thermostat housing bolt/stud and tighten the bolt/stud to 25 Nm. After that install the radiator outlet hose to the thermostat housing and place the radiator outlet hose clamp at the thermostat housing. Finally, install the air cleaner outlet duct and fill the cooling system.