Notes: Illegal for installation in NY on vehicles equipped w/Calif emission systems; Universal Fit; Fed & Calif Emission systems; Not legal for use in Calif
Catalytic Converter Body Length: 9"
Catalytic Converter Body Shape: Round
Catalytic Converter Overall Length: 15"
Catalytic Inlet Diameter: 2.5"
Catalytic Outlet Diameter: 2.5"
Catalytic Series: OBDII
Converter Body Material: Aluminized Steel
Converter Configuration: Universal Fit
O2 Sensor Port: No
Rated: 5.9L - 6,875 Lbs. GVW
UPC: 841809129741
Part Description: 2007 Chevrolet Monte Carlo OBDII Universal Fit Round Body Catalytic Converter
Other Names: Catalytic Converter, Converter & Pipe
Item Dimensions: 36.7 x 13.8 x 6.9 inches
Item Weight: 16.90 Pounds
Fitment Type: Direct Replacement
Part Description: 2007 Chevrolet Monte Carlo 3Way Catalytic Convertor Assembly (W/ Exhaust Manifold P
More Info
Vehicle Fitment
2007 Chevrolet Monte Carlo | SS | 8 Cyl 5.3 L GAS
FAQ for Catalytic Converter Repair
Q: How do you install the catalytic converter?
A:
You can install the catalytic converter insulators, the HO2S, the CPA retainer, and the intake manifold cover.
By Omar
GM Specialist
15/03/2022
Q: How do you install the converter hanger?
A:
You can install the catalytic converter pipe hangers and remove the support.
By Omar
GM Specialist
15/03/2022
Q: What is the proper way to remove the converter hanger?
A:
The proper way is to support the exhaust system and remove the catalytic converter pipe hangers.
By Omar
GM Specialist
10/03/2022
Q: What is the removal procedure for the catalytic converter?
A:
The procedure is to remove the intake manifold cover, the CPA retainer, the exhaust manifold heat shield, and lastly the catalytic converter.
By Bob
GM Specialist
09/03/2022
FAQ for Other Repair Info
Q: How do I install the cabin air filter?
A:
First, place the Cabin Air Filter into the filter housing next you'll need to install the water deflector cover and the air inlet grill panel. Then position the washer hose into the right air inlet grille panel clips. Install the rear hood seal and close the hood. Lastly, put the windshield wipers back in their original position.
Q: How do I install the Camshaft Position Actuator Magnet?
A:
Start with installing the Camshaft Position Actuator Magnet O-ring seal and magnet. Then install the bolts that attach the sensor. Connect the camshaft position actuator magnet sensor to the electrical connector. Lastly, install the manifold intake cover.
Q: How do I install the Drive Belt Idler Pulley?
A:
Start with attaching the required drive belt Idler Pulley, install the drive belt idler pulley bolt, and tighten it to 50 Nm (37 LB-FT). Lastly, install the drive belt.