Notes: Gap 0.040; DENSO is OE Manufacturer / Iridium Long Life Plug - Patented Iridium Alloy Plug (90% Ir) w/Platinum Ground Strap
Center Electrode Core Material: Copper
Center Electrode Tip Material: Iridium-Rhodium Alloy
Ground Configuration: Standard
Ground Electrode Core Material: Nickel
Ground Electrode Quantity: 1
Ground Electrode Tip Design: Platinum Chip
Hex Size: 16.0
Manufacturer Heat Range: 16
Pre-Gap Size: 0.040
Reach: 18.00
Resistance: 5000
Seat Type: Tapered
UPC: 042511050907
Part Description: 2007 Chevrolet Malibu Iridium Long-Life™ Spark Plug
More Info
Vehicle Fitment
2007 Chevrolet Malibu | All Trims | 6 Cyl 3.9L
2007 Chevrolet Malibu | All Trims | 6 Cyl 3.5L
FAQ for Spark Plug Repair
Q: How do I install the spark plug?
A:
Before installing the spark plug be sure to inspect the gap on the new spark plugs, it is recommended you re-gap the new spark plugs. Next, install the spark plugs to 20 Nm (15 LB-FT) and install the ignition coils.
By Omar
GM Specialist
25/03/2022
Q: How do I remove the spark plugs?
A:
First, you will need to remove the ignition coils. Before removing the spark plugs be sure that the outside has been cleaned and cleared of any debris. After cleaning, remove the spark plug.
By Bob
GM Specialist
24/03/2022
FAQ for Other Repair Info
Q: How do I install the Blower Motor Resistor?
A:
Start with installing the Blower Motor Resistor, the blower motor resistor wire harness connector, and the right closeout panel.
Q: How do I install the blower motor?
A:
Start with installing the motor blower seal, the Blower Motor, the blower motor attachment ring if reusing the blower, the blower motor wire harness connector, and the right closeout panel.
Q: How do I install the fuel injectors?
A:
Lubricate the new injector O-rings with clean engine oil. Install the new Fuel Injector upper O-ring, the new fuel injector lower O-ring, the fuel injector, the fuel injector retainer, and the fuel rail.